Refer toĪppendix A for the procedures to initialize and reload devices. Note: Make sure that the router and switch have been erased and have no startup configurations. Refer to the Router Interface Summary Table at the end of this lab for the Other routers, switches, and Cisco IOS versions can be used.ĭepending on the model and Cisco IOS version, the commands available and output produced might varyįrom what is shown in the labs. The switches used are Cisco Catalyst 2960 with Cisco Note: The routers used with CCNA hands-on labs are Cisco 1941 Integrated Services Routers (ISRs) withĬisco IOS Release 15.2(4)M3 (universalk9 image). PC-B can acquire an IP address and then verify connectivity.įor review purposes, this lab provides the commands necessary for specific router configurations. In Part 4, you will configure IPv6 on the router so that In Part 3, you will use SSH to connect to the router remotely and utilize IOS commands to retrieve informationįrom the device to answer questions about the router. Part 4: Configure IPv6 and Verify Connectivity Background / Scenario (2) ![]() ![]() Interpret the output from the routing table. Interpret the output from the startup configuration. Retrieve hardware and software information from the router. Assign static IPv4 information to the PC interfaces. Part 2: Configure Devices and Verify Connectivity Initialize and restart the router and switch. Cable equipment to match the network topology. Part 1: Set Up the Topology and Initialize Devices ![]() Instructor Note: Red font color or Gray highlights indicate text that appears in the instructor copy only.ĭevice Interface IP Address Subnet Mask Default Gateway Lab – Configuring Basic Router Settings with IOS CLI (Instructor Version)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |